Medical Journals

The Biphasic Force-velocity Relationship in Whole Rat Skeletal Muscle in Situ.

Authors:
  • Devrome A N
  • MacIntosh B R

From: Faculty of Kinesiology, University of Calgary, Calgary, Alberta, Canada T2N 1N4.

Journal of applied physiology (Bethesda, Md. : 1985)

  • Publish Date: Jun 2007
  • ISSN: 8750-7587
  • Volume: 102
  • Issue: 6
  • Pages: 2294-300
  • Medium: Print
  • Language: English
  • Citation (JAMA): Devrome A N, MacIntosh B R, et al. The Biphasic Force-velocity Relationship in Whole Rat Skeletal Muscle in Situ.. J. Appl. Physiol. Jun 2007;102:2294-300

Abstract

Edman has reported that the force-velocity relationship (FVR) departs from Hill’s classic hyperbola near 0.80 of measured isometric force (J Physiol 404: 301-321, 1988). The purpose of this study was to investigate the biphasic nature of the FVR in the rested state and after some recovery from fatigue in the rat medial gastrocnemius muscle in situ. Force-velocity characteristics were determined before and during recovery from fatigue induced by intermittent stimulation at 170 Hz for 100 ms each second for 6 min. Force-velocity data were obtained for isotonic contractions with 100 ms of 200-Hz stimulation, including several measurements with loads above 0.80 of measured isometric force. The force-velocity data obtained in this study were fit well by a double-hyperbolic equation. A departure from Hill’s classic hyperbola was found at 0.88+/-0.01 of measured isometric force, which is higher than the approximately 0.80 reported by Edman et al. for isolated frog fibers. After 45 min of recovery, maximum shortening velocity was 86+/-2% of prefatigue, but neither curvature nor predicted isometric force was significantly different from prefatigue. The location of the departure from Hill’s classic hyperbola was not different after this recovery from the fatiguing contractions. Including an isometric point in the data set will not yield the same values for maximal velocity and the degree of curvature as would be obtained using the double hyperbola approach. Data up to 0.88 of measured isometric force can be used to fit data to the Hill equation.

Mesh Headings (Keywords): Animals, Computer Simulation, Female, Models, Biological, Muscle Contraction, Muscle Fatigue, Muscle, Skeletal, Rats, Rats, Sprague-Dawley, Stress, Mechanical


Check for Full Text / PubMed Unique Identifier (PMID): 17412793


This abstract is part of PubMed, a service of the U.S. National Library of Medicine. PubMed includes more than 17 million citations from MEDLINE and other life science journals for biomedical articles. See Copyright and Disclaimers.

Linked medical terms appearing on this page are added by Healia to help readers find more information and are not part of the original PubMed document.

The data herein was last updated on July 8th, 2008 and may not reflect the most current and accurate data available from NLM.


Advertisements

About | Privacy Policy | Business Solutions | Advertise | Contact | Add Healia to your site

©2012. Healia / Meredith Corporation  

Use of this site constitutes acceptance of our Terms of Service and Privacy Policy. All content on this Web site, including medical opinion and any other health-related information, is for informational purposes only and should not be used for a specific diagnosis or individual treatment plan for any situation. Use of this site and the information contained herein does not create a doctor-patient relationship. Always seek the direct advice of your doctor in connection with any questions or issues you may have regarding your own health or the health of others.